Nordic Semiconductor

DEVZONE FORUM

I am using the mesh SDK 2.1.1 and have one node that uses the serial API. That node sends mesh packets to the network via the PacketSend serial opcode. This command uses an indirect address via an address handle that I must 1st have to register via the AddPublicationAdd command.In my scenario I may have to potentially have to send to packets to any address < 0x7FF as well as the group address. What is the reason for using handles to an address? In my use case I potentially have to add and remove addres...

Hello, I want to set the nrf24le1 module into register retention mode with timers ON but clock source from XOSC32K. I need this power saving code in my project. Also can I wake from the register retention mode with pinwake up? I did look into the bit setting here0xA4 Register to be set2:0 W/RSet system to power down if different from 000001: set system to DeepSleep010: set system to Memory retention, timer off011: set system to Memory retention, timer on100: set system to Register retention101: reser...

Dear all, We are programming the FICR and have found very little documentation on the random number generator fields: - TRNG90B.BYTES - TRNG90B.RCCUTOFF - TRNG90B.APCUTOFF - TRNG90B.STARTUP - TRNG90B.ROSC1 - TRNG90B.ROSC2 - TRNG90B.ROSC3- TRNG90B.ROSC4We have managed to locate the specification for 800-90B (citeseerx.ist.psu.edu/.../download which briefly explains the value for TRNG90B.RCCUTOFF, however, it is unclear how to populate the rest of the fields.If anybody knows anything about how to correctly ...

DEVZONE BLOG FEED

This blog describes how you can setup a Segger Embedded Studio example for PCA10040E (emulating nRF52810) from nRF5 SDK 14.2 to use S132 v5.1.0, instead of S112. The procedure should be similar for the other toolchains.nRF5 SDK 14.2 officially ...(read more)...

This is a follow-up to my previous blog post; adding custom commands to a BLE example.I hope it was interesting to see an example of adding the vendor specific Nordic UART service (NUS) into another project.For completeness, I wanted to share step...(read more)...

A common thing to do is to use the Nordic UART Service for quick prototyping.Often the example itself is used as a starting point (ble_app_uart), but sometimes we use other starting points, and want to include parts of another example in our ap...(read more)...

eZ Publish™ copyright © 1999-2018 eZ Systems AS