Nordic Semiconductor

DEVZONE FORUM

The question is in the title. I found this addition a nice optimization to be used where available (that is to this day, on NRF52840 only, according to the latest Product Specifications), but as far as I can see, the READYNEXT bit is as good as dead, contrary to the old READY flag.But perhaps am I missing something?(Steps to reproduce: * Write 1 to NVMC->CONFIG * [ Perhaps write a word to flash. I would prefer the flag to be set before the first write, but I tried anyway. ]* Read NVMC->READYNEXT til...

19.06.2018

Protect UICR

Hello i have a rigado BMD-300 module and i would like to flash a new version of softdevice app and bootloader but i want to protect the UICR memory because that is where the MAC addr of the module is stored. Is there any way to flash everything without touching the UICR ?If so can you tell me a better way do to this ?Thanks for the help...

On my custom board I have a button BUTTON_1 in between supply voltage (Vbatt = 3V) and input on nRF52832 - therefore input will receive 3 Volts directly.I have configured BUTTON_1 to: { BUTTON_1, false, NRF_GPIO_PIN_NOPULL, button_event_handler }However when I push it the response comes with + 10 seconds delay, sometimes more....

DEVZONE BLOG FEED

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made.Please also review the following blog post fo...(read more)...

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible power in your design.SystemBy enabling and p...(read more)...

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK is tailored towards remote control ...(read more)...

eZ Publish™ copyright © 1999-2018 eZ Systems AS